Before You Begin - Cisco ONS 15454 Series Procedure Manual

Install Cards and Fiber-Optic Cable
The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
Note
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter explains how to install the Cisco ONS 15454 cards and fiber-optic cable (fiber).

Before You Begin

This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
May 2006
NTP-A15 Install the Common Control Cards, page
installing any other cards.
NTP-A16 Install the OC-N Cards, page
NTP-A17 Install the Electrical Cards, page
NTP-A246 Install Ethernet Cards and Connectors, page
NTP-A274 Install the FC_MR-4 Cards, page
NTP-A316 Install the Filler Cards, page
NTP-A247 Install Fiber-Optic Cables on OC-N Cards, page
install fiber on OC-N cards, Ethernet Gigabit Interface Converters (GBICs), or small form-factor
pluggables (SFPs).
NTP-A245 Route Fiber-Optic Cables, page
NTP-A116 Remove and Replace a Card, page
and replace a card, including deleting the card from Cisco Transport Controller (CTC) and changing
an OC-N card without losing the card's provisioning.
NTP-A20 Replace the Front Door, page
procedure to replace the front door and ground strap after installing cards and fiber.
C H A P T E R
2-2—Complete this procedure first before
2-6—Complete as needed.
2-8—Complete as needed.
2-10—Complete as needed.
2-11—Complete as needed.
2-13—Complete as needed.
2-14—Complete this procedure to
2-17—Complete as needed.
2-17—Complete this procedure as needed to remove
2-18—If the front door was removed, complete this
Cisco ONS 15454 Procedure Guide, R5.0
2
2-1