Cisco ONS 15454 Series Procedure Manual page 803

Chapter 22 DLPs A500 to A599
Table 22-5
Variable
iflnOctets
iflnUcastPkts
ifInMulticastPkts
ifInBroadcastPkts
ifInDiscards
iflnErrors
ifOutOctets
ifOutUcastPkts
ifOutMulticastPkts
ifOutBroadcastPkts
ifOutDiscards
dot3statsAlignmentErrors
dot3StatsFCSErrors
dot3StatsSingleCollisionFrames
dot3StatsMutlipleCollisionFrames
dot3StatsDeferredTransmissions
dot3StatsLateCollisions
October 2005
Ethernet Threshold Variables (MIBs)
Definition
Total number of octets received on the interface, including
framing octets
Total number of unicast packets delivered to an appropriate
protocol
(G-Series, CE-Series, and ML-Series only.) Number of multicast
frames received error free
(G-Series, CE-Series, and ML-Series only.) The number of
packets, delivered by this sublayer to a higher (sub)layer, that
were addressed to a broadcast address at this sublayer
(G-Series, CE-Series, and ML-Series only.) The number of
inbound packets that were chosen to be discarded even though no
errors had been detected to prevent their being deliverable to a
higher-layer protocol
Number of inbound packets discarded because they contain
errors
Total number of transmitted octets, including framing packets
Total number of unicast packets requested to transmit to a single
address
(G-Series, CE-Series, and ML-Series only.) Number of multicast
frames transmitted error free
(G-Series, CE-Series, and ML-Series only.) The total number of
packets that higher-level protocols requested be transmitted, and
that were addressed to a broadcast address at this sublayer,
including those that were discarded or not sent
(G-Series only) The number of outbound packets that were
chosen to be discarded even though no errors had been detected
to prevent their being transmitted
Number of frames with an alignment error, that is, the length is
not an integral number of octets and the frame cannot pass the
frame check sequence (FCS) test
Number of frames with frame check errors, that is, there is an
integral number of octets, but an incorrect FCS
(Not supported by E-Series or G-Series.) Number of successfully
transmitted frames that had exactly one collision
(Not supported by E-Series or G-Series.) Number of successfully
transmitted frames that had multiple collisions
(Not supported by E-Series or G-Series.) Number of times the
first transmission was delayed because the medium was busy
(Not supported by E-Series or G-Series.) Number of times that a
collision was detected later than 64 octets into the transmission
(also added into collision count)
DLP-A533 Create Ethernet RMON Alarm Thresholds
Cisco ONS 15454 Procedure Guide, R5.0
22-29