Dlp- A256 View Ethernet Statistics Pm Parameters - Cisco ONS 15454 Series Procedure Manual

DLP-A256 View Ethernet Statistics PM Parameters
Wait 60 seconds, then repeat Steps
Step 12
at the start of the procedure.
Verify that the cross-connect card appears as you noted in Step 6.
Step 13
Return to your originating procedure (NTP).
Step 14
Note
DLP-A256 View Ethernet Statistics PM Parameters
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the E-Series or G-Series Ethernet card where you want to view PM counts.
The card view appears.
Step 2 Click the Performance > Statistics tabs
Cisco ONS 15454 Procedure Guide, R5.0
19-38
During a maintenance side switch or soft reset of an active XC10G card, the 1+1 protection
group might display a protection switch. To disallow the protection switch from being displayed,
the protection group should be locked at the node where XC switch or soft reset of an active XC
switch is in progress.
This task enables you to view current statistical PM counts on an
Ethernet card and port to detect possible performance problems.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
7 through 9 to return the active/standby slots to their configuration
(Figure 19-4).
Chapter 19 DLPs A200 to A299
September 2005