Dlp- A196 Delete A Blsr From A Single Node - Cisco ONS 15454 Series Procedure Manual

DLP-A196 Delete a BLSR from a Single Node
Return to your originating procedure (NTP).
Step 6
DLP-A196 Delete a BLSR from a Single Node
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, display the node that was removed from the BLSR:
Step 1
•
•
Click the Provisioning > BLSR tabs.
Step 2
Highlight the ring and click Delete.
Step 3
In the Suggestion dialog box, click OK.
Step 4
In the confirmation message, confirm that this is the ring you want to delete. If so, click Yes.
Step 5
Return to your originating procedure (NTP).
Step 6
DLP-A197 Initiate a Path Protection Force Switch
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The Force Switch Away command overrides normal protective switching mechanisms. Applying this
Caution
command incorrectly can cause traffic outages.
Traffic is not protected during a Force protection switch.
Caution
Cisco ONS 15454 Procedure Guide, R5.0
18-68
This task deletes a BLSR from a node after you remove the node from the
BLSR.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
If the node that was removed is connected to the same LAN as your computer, from the File menu,
choose Add Node, then enter the node name or IP address.
If the node that was removed is not connected to the same LAN as your computer, you must connect
to the node using a direct connection. See
procedures.
This task switches all circuits on a path protection span to another span.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Maintenance or higher
Chapter 3, "Connect the PC and Log into the GUI"
Chapter 18 DLPs A100 to A199
for
March 2007