Dlp- A438 Change General Port Settings For The Fc_Mr-4 Card - Cisco ONS 15454 Series Procedure Manual

DLP-A438 Change General Port Settings for the FC_MR-4 Card
•
•
Click Apply.
Step 7
To close the Edit Circuit window, choose Close from the File menu.
Step 8
Step 9 Return to your originating procedure (NTP).
DLP-A438 Change General Port Settings for the FC_MR-4 Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 In node view, double-click the FC_MR-4 card where you want to change the port settings.
Step 2 Click the Provisioning > Port > General tabs.
Modify any of the settings described in
Step 3
Table 21-3
Parameter
Port
Port Name
Cisco ONS 15454 Procedure Guide, R5.0
21-16
OOS,MT—Puts the member cross-connects in the OOS-MA,MT service state. The maintenance
state does not interrupt traffic flow; it suppresses alarms and conditions and allows loopbacks to be
performed on the circuit. Use OOS,MT for circuit testing or to suppress circuit alarms temporarily.
Change the administrative state to IS; IS,AINS; or OOS,DSBLD when testing is complete.
OOS,OOG—(LCAS and Software–Link Capacity Adjustment Scheme [Sw-LCAS] VCAT only.)
Puts VCAT member cross-connects in the Out-of-Service and Management, Out-of-Group
(OOS-MA,OOG) service state. This administrative state is used to put a member circuit out of the
group and to stop sending traffic.
This task changes the general port settings for FC_MR-4 cards.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
FC_MR-4 Card General Port Settings
Description
(Display only.) Displays the port number. 1 through 4
Provides the ability to assign the
specified port a name.
Table 21-3.
Options
User-defined. Name can be up to
32 alphanumeric/special characters.
Blank by default.
See the
Port" task on page
Chapter 21 DLPs A400 to A499
"DLP-A314 Assign a Name to a
20-8.
March 2005