Ntp- A287 Replace An In-Service Cross-Connect Card - Cisco ONS 15454 Series Procedure Manual

Chapter 15 Maintain the Node
Table 15-2 ONS 15454 Timing Report (continued)
Item Description
SSM Indicates the
Quality SSM timing
quality.
SSM Indicates the
Changed date and time of
the last SSM
status change in
MM/DD/YY
HH:MM:SS
format.
Stop. You have completed this procedure.
NTP-A287 Replace an In-Service Cross-Connect Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning Do not reach into a vacant slot or chassis while you install or remove a module or a fan. Exposed
circuitry could constitute an energy hazard. Statement 206
Removing any active card from the ONS 15454 can result in traffic interruption. Use caution when
Caution
replacing cards and verify that only the standby card is being replaced.
Step 1 Complete the
Step 2 From the View menu choose Go to Network View.
Click the Alarms tab, then complete the following substeps:
Step 3
a.
b.
Determine the active cross-connect card (XCVT/XC10G). The ACT/STBY LED of the active card is
Step 4
green. The ACT/STBY LED of the standby card is amber.
December 2004
Option
8 to 10 SSM quality messages
might be displayed.
—
"DLP-A60 Log into CTC" task on page 17-66
Verify that the alarm filter is not on. See the
page 19-17 as necessary.
Verify that no unexplained alarms appear on the network. If unexplained alarms appear, resolve
them before continuing. Refer to the Cisco ONS 15454 Troubleshooting Guide if necessary.
Option Description
For a list of SSM message sets, see the Cisco ONS 15454
Reference Manual.
—
This procedure replaces an in service cross-connect card.
None
DLP-A37 Install the XCVT or XC10G Cards, page 17-45
As needed
Onsite or remote
Provisioning or higher
"DLP-A227 Disable Alarm Filtering" task on
NTP-A287 Replace an In-Service Cross-Connect Card
at the node where you will replace the card.
Cisco ONS 15454 Procedure Guide, R5.0
15-21