Figure 6-1 Setting Circuit Attributes For A Ds-1 Circuit - Cisco ONS 15454 Series Procedure Manual

NTP-A181 Create an Automatically Routed DS-1 Circuit
Protected Drops—Check this box if you want the circuit routed on protected drops only, that is, to
•
ONS 15454 cards that are in 1:1, 1:N, 1+1, or optimized 1+1 protection. If you check this box, CTC
displays only protected cards and ports as source and destination choices.
Figure 6-1
If the circuit will be routed on a path protection, complete the
Step 8
Selectors" task on page
Click Next.
Step 9
Complete the
Step 10
In the Circuit Routing Preferences area
Step 11
available; choose either, both, or none based on your preferences.
Using Required Nodes/Spans—Check this check box if you want to specify nodes and spans to
•
include or exclude in the CTC-generated circuit route.
Including nodes and spans for a circuit ensures that those nodes and spans are in the working path
of the circuit (but not the protect path). Excluding nodes and spans ensures that the nodes and spans
are not in the working or protect path of the circuit.
Review Route Before Creation—Check this check box if you want to review and edit the circuit
•
route before the circuit is created.
Cisco ONS 15454 Procedure Guide, R5.0
6-8
Setting Circuit Attributes for a DS-1 Circuit
19-12. Otherwise, continue with the next step.
"DLP-A95 Provision a DS-1 Circuit Source and Destination" task on page
(Figure
Chapter 6
"DLP-A218 Provision Path Protection
6-2), choose Route Automatically. Two options are
Create Circuits and VT Tunnels
17-96.
August 2005