Cisco ONS 15454 Series Procedure Manual page 611

Chapter 19 DLPs A200 to A299
Complete the following information in the fields listed:
Step 2
IP Address—Type the IP address assigned to the ONS 15454 node.
•
Note
Suppress CTC IP Display—Check this check box if you want to prevent the node IP address from
•
being displayed in CTC (IP Address field, information area) to users with Provisioner, Maintenance,
or Retrieve security levels. (The IP address suppression is not applied to users with Superuser
security level.) If the IP address is not suppressed, it is shown in the IP Address field.
• LCD IP Display—Choose one of the following:
–
–
–
• Default Router—If the ONS 15454 is connected to a LAN, enter the IP address of the default router.
The default router forwards packets to network devices that the ONS 15454 cannot directly access.
This field is ignored if any of the following are true:
–
–
–
• Forward DHCP Request To—Check this check box to enable DHCP. Also, enter the DHCP server
IP address in the Request To field. Unchecked is the default. If you will enable any of the gateway
settings to implement the ONS 15454 SOCKS proxy server features, leave this field blank.
Note
MAC Address—(Display only.) Displays the ONS 15454 IEEE 802 MAC address.
•
Net/Subnet Mask Length—Type the subnet mask length (decimal number representing the subnet
•
mask length in bits) or click the arrows to adjust the subnet mask length. The subnet mask length is
the same for all ONS 15454s in the same subnet.
TCC CORBA (IIOP) Listener Port—Sets the ONS 15454 Internet Inter-Orb Protocol (IIOP) listener
•
port used for communication between the ONS 15454 and CTC computers. This field is generally
not changed unless the ONS 15454 resides behind a firewall that requires a different port. See the
"NTP-A27 Set Up the ONS 15454 for Firewall Access" procedure on page 4-8
information.
September 2005
If TCC2P cards are installed, secure mode is available. When secure mode is off, the IP
address entered in the IP Address field applies to the ONS 15454 backplane LAN port and
the TCC2P LAN port. When secure mode is on, IP Address shows the address assigned to
the TCC2P LAN port.
Allow Configuration—Displays the node IP address on the LCD and allows users to change the
IP settings using the LCD. This option enables the
Router, and Network Mask Using the LCD" task on page
Display Only—Displays the node IP address on the LCD but does not allow users to change the
IP address using the LCD.
Suppress Display—Suppresses the node IP address display on the LCD.
The ONS 15454 is not connected to a LAN.
SOCKS proxy server is enabled and the ONS 15454 is provisioned as an end network element
(ENE).
Open Shortest Path First (OSPF) is enabled on both the ONS 15454 and the LAN where the
ONS 15454 is connected.
If you enable DHCP, computers connected to an ONS 15454 node can obtain temporary IP
addresses from an external DHCP server. The ONS 15454 only forwards DHCP requests; it
does not act as a DHCP server.
DLP-A249 Provision IP Settings
"DLP-A64 Set the IP Address, Default
17-71.
for more
Cisco ONS 15454 Procedure Guide, R5.0
19-31