Ntp- A109 Restore The Database - Cisco ONS 15454 Series Procedure Manual

Chapter 15 Maintain the Node
You must back up and restore the database for each node on a circuit path in order to maintain a complete
Note
circuit.
The following parameters are not backed up and restored: node name, IP address, subnet mask and
Note
gateway, and Internet Inter-ORB Protocol (IIOP) port. If you change the node name and then restore a
backed up database with a different node name, the circuits map to the new node name. Cisco
recommends keeping a record of the old and new node names.
Complete the
Step 1
already logged in, continue with
Click the Maintenance > Database tabs.
Step 2
Click Backup.
Step 3
Save the database on the workstation's hard drive or on network storage. Use an appropriate file name
Step 4
with the .db file extension; for example, database.db.
Click Save.
Step 5
Click OK in the confirmation dialog box.
Step 6
Stop. You have completed this procedure.
NTP-A109 Restore the Database
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution E1000-2 cards lose traffic for approximately 90 seconds when an ONS 15454 database is restored.
Traffic is lost during the period of spanning tree reconvergence. The CARLOSS alarm appears and clears
during this period.
If you are restoring the database on multiple nodes, wait approximately one minute after the
Caution
TCC2/TCC2P reboot has completed on each node before proceeding to the next node.
TCC2P cards can be used in single IP address (repeater) and dual IP address (secured) mode. The
Caution
secured mode has advanced features that affect database restore. A database from a secured node cannot
be loaded on an unsecured repeater node. An unsecured database can be loaded onto a secured node but
December 2004
"DLP-A60 Log into CTC" task on page 17-66
Step 2.
This procedure restores the TCC2/TCC2P software database.
None
NTP-A108 Back Up the Database, page 15-4
As needed
Onsite or remote
Superuser
NTP-A109 Restore the Database
at the node you want to back up. If you are
Cisco ONS 15454 Procedure Guide, R5.0
15-5