Dlp- A416 View Circuit Information - Cisco ONS 15454 Series Procedure Manual

DLP-A416 View Circuit Information
Return to your originating procedure (NTP).
Step 5
DLP-A416 View Circuit Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Navigate to the appropriate Cisco Transport Controller (CTC) view:
Step 1
•
•
•
Click the Circuits tab. The Circuits tab shows the following information:
Step 2
•
•
•
•
•
•
•
Cisco ONS 15454 Procedure Guide, R5.0
21-2
This task enables you to view information about circuits, such as name,
type, size, and direction.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
To view circuits for an entire network, from the View menu, choose Go to Network View.
To view circuits that originate, terminate, or pass through a specific node, from the View menu,
choose Go to Other Node, then choose the node you want to search and click OK.
To view circuits that originate, terminate, or pass through a specific card, in node view, double-click
the card containing the circuits you want to view.
In node or card view, you can change the scope of the circuits that appear by choosing Card
Note
(in card view), Node, or Network from the Scope drop-down list in the bottom right corner
of the Circuits window.
Name—Name of the circuit. The circuit name can be manually assigned or automatically generated.
Type—Circuit types are STS (STS circuit), VT (VT circuit), VTT (VT tunnel), VAP (VT
aggregation point), OCHNC (dense wavelength division multiplexing [DWDM] optical channel
network connection), STS-v (STS virtual concatenated [VCAT] circuit), and VT-v (VT VCAT
circuit).
Size—Circuit size. VT circuit size is 1.5. STS circuit sizes are 1, 3c, 6c, 9c, 12c,18c, 24c, 36c, 48c,
and 192c. OCHNC circuit sizes are Equipped not specific, Multi-rate, 2.5 Gbps No FEC (forward
error correction), 2.5 Gbps FEC, 10 Gbps No FEC, and 10 Gbps FEC (DWDM only; refer to the
Cisco ONS 15454 DWDM Installation and Operations Guide). VCAT circuit sizes are VT1.5-nv,
STS-1-nv, STS-3c-nv, and STS-12c-nv, where n is the number of members.
OCHNC Wlen—For OCHNCs, the wavelength provisioned for the optical channel network
connection. (DWDM only; refer to the Cisco ONS 15454 DWDM Installation and Operations
Guide.)
Direction—The circuit direction, either two-way or one-way.
OCHNC Dir—The direction of the OCHNC, either East to West or West to East. (DWDM only; refer
to the Cisco ONS 15454 DWDM Installation and Operations Guide.)
Protection—The type of circuit protection. See
Chapter 21
Table 21-1 for a list of protection types.
DLPs A400 to A499
March 2005