Figure - Cisco ONS 15454 Series Procedure Manual

NTP-A109 Restore the Database
the database will follow the node characteristics (that is, become secured). A secured database cannot
be loaded onto a TCC2; the restore is disallowed because the TCC2 card cannot boot in secure mode.
For more information about the dual IP secured mode, refer to the
Access" procedure on page
To avoid a node IP and secure IP ending up in the same domain after restoring a database, ensure that
Caution
the node IP stored in the database differs in domain from that of the node in repeater mode. Also, after
restoring a database, ensure that the node IP and secure IP differ in domain.
The following parameters are not backed up and restored: node name, IP address, subnet mask and
Note
gateway, and IIOP port. If you change the node name and then restore a backed up database with a
different node name, the circuits map to the new renamed node. Cisco recommends keeping a record of
the old and new node names.
ML-Series Ethernet cards must be reset after a database restore. For more information about restoring
Note
these cards, refer to the Ethernet Card Software Feature and Configuration Guide for the Cisco ONS 15454,
Cisco ONS 15454 SDH, and Cisco ONS 15327.
If you want to revert to a previously used software load, consult the platform-specific upgrade
Note
documentation for instructions.
Complete the
Step 1
database. If you are already logged in, continue with Step 2.
Ensure that no ring or span (four-fiber only) switch events are present; for example, ring-switch east or
Step 2
west, and span-switch east or west. In network view, click the Conditions tab and click Retrieve to view
a list of conditions.
Step 3 If switch events need to be cleared, in node view click the Maintenance > BLSR tabs and view the
West Switch and East Switch columns.
a. If a switch event (not caused by a line failure) is present, choose CLEAR from the drop-down list
and click Apply.
b. If a switch event caused by the Wait to Restore (WTR) condition is present, choose CLEAR from
the drop-down list and click Apply.
When a switch event is cleared, NO COMMAND appears in the column to indicate that the switch event
is no longer in effect.
Step 4 In node view, click the Maintenance > Database tabs.
(The TCC2P tab is similar.)
Cisco ONS 15454 Procedure Guide, R5.0
15-6
4-7.
"DLP-A60 Log into CTC" task on page 17-66
Chapter 15
"NTP-A169 Set Up CTC Network
at the node where you are restoring the

Figure 15-2

shows this tab for the TCC2 card.
Maintain the Node
December 2004