Dlp- A262 Filter The Display Of Circuits - Cisco ONS 15454 Series Procedure Manual

DLP-A262 Filter the Display of Circuits
Click Refresh. The PM counts for the newly selected port appear.
Step 4
Return to your originating procedure (NTP).
Step 5
DLP-A262 Filter the Display of Circuits
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Navigate to the appropriate CTC view:
Step 1
•
•
•
Click the Circuits tab.
Step 2
Set the attributes for filtering the circuit display:
Step 3
a.
b.
Cisco ONS 15454 Procedure Guide, R5.0
19-44
This task filters the display of circuits in the Circuits window. You can
filter the circuits in network, node, or card view based on circuit name,
size, type, direction, and other attributes.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
To filter network circuits, from the View menu, choose Go to Network View.
To filter circuits that originate, terminate, or pass through a specific node, from the View menu,
choose Go to Other Node, then choose the node you want to search and click OK.
To filter circuits that originate, terminate, or pass through a specific card, double-click the card on
the shelf graphic in node view to open the card in card view.
Click the Filter button.
In the Circuit Filter dialog box, set the filter attributes by choosing one or more of the following:
Name—Enter a complete or partial circuit name to filter circuits based on the circuit name;
•
otherwise leave the field blank.
Direction—Choose one: Any (direction not used to filter circuits), 1-way (display only one-way
•
circuits), or 2-way (display only two-way circuits).
OCHNC Dir—(DWDM OCHNCs only; refer to the Cisco ONS 15454 DWDM Installation and
•
Operations Guide.) Choose one: East to West (displays only east-to-west circuits) or West to
East (displays only west-to-east circuits).
OCHNC Wlen—(DWDM OCHNCs only; refer to the Cisco ONS 15454 DWDM Installation
•
and Operations Guide.) Choose an OCHNC wavelength to filter the circuits. For example,
choosing 1530.33 displays channels provisioned on the 1530.33 nm wavelength.
Status—Choose one: Any (status not used to filter circuits), DISCOVERED (display only
•
discovered circuits), DISCOVERED_TL1 (display only TL1-created or TL1-like,
CTC-created circuits), PARTIAL (display only partial circuits, that is, circuits missing a
connection or span to form a complete path), or PARTIAL_TL1 (display only TL1-created
circuits and TL1-like CTC-created circuits that are missing a cross-connect or span to form a
complete path). For more information about circuit statuses, see
Although other statuses are described in the table, filtering is only supported for
DISCOVERED, DISCOVERED_TL1, PARTIAL, and PARTIAL_TL1 circuits.
Chapter 19 DLPs A200 to A299
Table 21-2 on page 21-3.
September 2005