Cisco ONS 15454 Series Procedure Manual page 240

NTP-A146 Test E-Series Circuits
NTP-A146 Test E-Series Circuits
Purpose
Tools/Equipment
Prerequisite Procedures This procedure assumes you completed facility loopback tests to test the
Required/As Needed
Onsite/Remote
Security
Complete the
Step 1
On the shelf graphic, double-click the circuit source card.
Step 2
Click the Provisioning > Ether Port tabs.
Step 3
Step 4 Verify the following settings:
•
•
•
•
Click the Ether VLAN tab. If the E-Series cards is not in port-mapped mode, verify that the source port
Step 5
is on the same VLAN as the destination port.
Repeat Steps
Step 6
At the destination node, connect the Ethernet test set to the destination port and configure the test set to
Step 7
send and receive the appropriate Ethernet traffic.
Note
Cisco ONS 15454 Procedure Guide, R5.0
6-72
This procedure tests circuits created on E-Series Ethernet cards
provisioned for multicard EtherSwitch, single-card EtherSwitch, or
port-mapped mode.
Ethernet test set and appropriate fibers
fibers and cables from the source and destination ONS 15454s to the fiber
distribution panel or the DSX, and one of the following procedures:
NTP-A191 Create an E-Series EtherSwitch Circuit (Multicard or
Single-Card Mode), page 6-56
NTP-A192 Create a Circuit for an E-Series Card in Port-Mapped Mode,
page 6-59
NTP-A142 Create an E-Series Shared Packet Ring Ethernet Circuit, page
6-61
NTP-A143 Create an E-Series Hub-and-Spoke Ethernet Configuration,
page 6-64
NTP-A145 Create an E-Series Multicard EtherSwitch Manual
Cross-Connect, page 6-69
As needed
Onsite
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
Mode—Auto, 10 Half, 10 Full, 100 Half, or 100 Full.
Enabled—Checked.
Priority—Set to the priority level indicated by the circuit or site plan. Priority does not apply to
E-Series cards in port-mapped mode.
Stp State—Checked if Spanning Tree Protocol is enabled for the circuit. Stp does not apply to
E-Series cards in port-mapped mode.
1 through 5 for the destination node.
At this point, you are not able to send and receive Ethernet traffic.
Chapter 6 Create Circuits and VT Tunnels
at the ONS 15454 source Ethernet node.
August 2005