Figure 15-9 Recording The Old Mac Address Before Replacing The Aip; Figure 15-10 Circuit Repair Information - Cisco ONS 15454 Series Procedure Manual

NTP-A290 Replace the Alarm Interface Panel
Figure 15-9
The Repair Circuits dialog box appears
Step 25
Finish.
Figure 15-10
Note
When the circuit repair is complete, the Circuits Repaired dialog box appears.
Click OK.
Step 26
In the node view of the new node, click the Circuits tab. Check to ensure that all circuits listed have a
Step 27
status of DISCOVERED. If all circuits listed are not DISCOVERED, call the Cisco Technical Support
to open a Return Material Authorization (RMA). See the
and Security Guidelines" section on page
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
15-30
Recording the Old MAC Address Before Replacing the AIP
Circuit Repair Information
The CTC session freezes until all circuits are repaired. Circuit repair can take up to five minutes
or more depending on the number of circuits provisioned.
(Figure 15-10). Read the information in the dialog box and click
"Obtaining Documentation, Obtaining Support,
lvi.
Chapter 15 Maintain the Node
December 2004