Dlp- A95 Provision A Ds-1 Circuit Source And Destination - Cisco ONS 15454 Series Procedure Manual

DLP-A95 Provision a DS-1 Circuit Source and Destination
b.
c.
d.
e.
Step 5 Return to your originating procedure (NTP).
DLP-A95 Provision a DS-1 Circuit Source and Destination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
After you have selected the circuit properties in the Circuit Source dialog box according to the specific
Note
circuit creation procedure, you are ready to provision the circuit source.
From the Node drop-down list, choose the node where the source will originate.
Step 1
From the Slot drop-down list, choose the slot containing the DS1-14, DS1N-14, DS3XM-6, or
Step 2
DS3XM-12 card where the circuit will originate.
Note
Only if you chose DS3XM-6 or DS3XM-12 as the card, choose the port from the Port drop-down list.
Step 3
From the DS-1 drop-down list, choose the source DS-1.
Step 4
If you need to create a secondary source, for example, a path protection bridge/selector circuit entry
Step 5
point in a multivendor path protection, click Use Secondary Source and repeat Steps
define the secondary source. If you do not need to create a secondary source, continue with
Click Next.
Step 6
From the Node drop-down list, choose the destination (termination) node.
Step 7
From the Slot drop-down list, choose the slot containing the destination card. The destination is typically
Step 8
a DS-1 card. You can also choose an OC-N card to map the DS-1 to a VT1.5 for OC-N transport.
Depending on the destination card, choose the destination port, STS, VT, or DS1 from the drop-down
Step 9
lists that appear based on the card selected in
CTC does not display ports, STSs, VTs, or DS1s already used by other circuits. If another user working
Cisco ONS 15454 Procedure Guide, R5.0
17-96
Choose CLEAR from the drop-down list.
Click Apply.
In the Confirm UPSR Switch dialog box, click Yes.
In the Protection Switch Result dialog box, click OK.
In the Circuits on Span window, the Switch State for all path protection circuits is CLEAR.
This task provisions an electrical circuit source and destination for a DS-1
circuit.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
A VT circuit source or destination can be on the STS grooming endpoint of a portless
aggregation circuit.
Step 8. See Table 6-2 on page 6-3
Chapter 17 DLPs A1 to A99
1 through 4 to
Step 6.
for a list of valid options.
March 2005