Ntp- A156 Convert A Point-To-Point Or Linear Adm To A Path Protection Manually - Cisco ONS 15454 Series Procedure Manual

NTP-A156 Convert a Point-to-Point or Linear ADM to a Path Protection Manually
NTP-A156 Convert a Point-to-Point or Linear ADM to a Path
Protection Manually
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Caution This procedure is service affecting. All circuits are deleted and reprovisioned.
Complete the
Step 1
ADM. If you are already logged in, continue with Step 2.
Complete the
Step 2
Complete the
Step 3
Complete the
Step 4
that supports the point-to-point or linear ADM span.
Complete the
Step 5
in all nodes that will be part of the path protection. Alternatively, if additional bandwidth is needed for
CTC management, complete the
Complete the
Step 6
Automatically Routed OC-N Circuit" procedure on page 6-38
time.
Note
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
13-12
This procedure upgrades a point-to-point system to a path protection
manually, that is, without using the in-service topology upgrade wizard.
Use this procedure if the wizard is unavailable or if you need to back out
of the wizard.
None
NTP-A124 Provision a Point-to-Point Network, page 5-3
NTP-A38 Provision a Linear ADM Network, page 5-6
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A298 Check the Network for Alarms and Conditions" task on page
"DLP-A189 Verify that a 1+1 Working Slot is Active" task on page 18-60
"DLP-A155 Delete a Protection Group" task on page 18-23
"DLP-A377 Provision Section DCC Terminations" task on page 20-61
"DLP-A378 Provision Line DCC Terminations" task on page
"DLP-A333 Delete Circuits" task on page 20-21
A path protection is the default configuration if the cards installed are installed and the DCCs
are configured.
Chapter 13 Convert Network Configurations
at a node on the point-to-point or linear
for each 1+1 protection group
at the protect cards
and the "NTP-A257 Create an
to delete and recreate the circuits one at a
or
19-63.
for each node.
20-62.
December 2004