Table 20-3 Line Options For The Ds3Xm-12 Parameters - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
Table 20-3
Parameter
Service State Identifies the autonomously generated
AINS Soak
SD BER
Line Type
Line Coding
March 2005
Line Options for the DS3XM-12 Parameters (continued)
Description
state that gives the overall condition of
the port. Service states appear in the
format: Primary State-Primary State
Qualifier, Secondary State.
Sets the automatic in-service soak period.
Sets the signal degrade bit error rate.
Defines the line framing type.
Defines the DS-1 transmission coding
type that is used.
DLP-A387 Change Line and Threshold Settings for the DS3XM-12 Card
Options
IS-NR—(In-Service and Normal)
•
The port is fully operational and
performing as provisioned.
OOS-AU,AINS—(Out-Of-Service
•
and Autonomous, Automatic
In-Service) The port is
out-of-service, but traffic is carried.
Alarm reporting is suppressed. The
ONS node monitors the ports for an
error-free signal. After an error-free
signal is detected, the port stays in
OOS-AU,AINS state for the duration
of the soak period. After the soak
period ends, the port service state
changes to IS-NR.
• OOS-MA,DSBLD—(Out-of-Service
and Management, Disabled) The port
is out-of-service and unable to carry
traffic.
OOS-MA,MT—(Out-of-Service and
•
Management, Maintenance) The port
is out-of-service for maintenance.
Alarm reporting is suppressed, but
traffic is carried and loopbacks are
allowed.
Duration of valid input signal, in
•
hh.mm format, after which the card
becomes in service (IS)
automatically
0 to 48 hours, 15-minute increments
•
1E-5
•
1E-6
•
1E-7
•
1E-8
•
1E-9
•
M13 - default
•
C BIT
•
B3ZS
Cisco ONS 15454 Procedure Guide, R5.0
20-75