Cisco ONS 15454 Series Procedure Manual page 797

Chapter 22 DLPs A500 to A599
Table 22-1
Parameter
Line
Length
Admin
State
Service
State
AINS Soak Sets the automatic
Table 22-2
Table 22-2
Parameter
Port
CV
October 2005
Line Options for the DS3i-N-12 Cards (continued)
Description
Defines the distance (in
feet) from backplane
connection to the next
termination point.
Sets the port service state
unless network conditions
prevent the change.
Identifies the
autonomously generated
state that gives the overall
condition of the port.
Service states appear in the
format: Primary
State-Primary State
Qualifier, Secondary State.
in-service soak period.
describes the values on the Provisioning > Line Thresholds tabs for the DS3i-N-12 cards.
Line Threshold Options for the DS3i-N-12 Cards
Description
(Display only.) Port number
Coding violations
DLP-A526 Change Line and Threshold Settings for the DS3i-N-12 Cards
Options
0 - 225 (default)
•
226 - 450
•
IS—Puts the port in service. The port service state
•
changes to In-Service and Normal (IS-NR).
IS,AINS—Puts the port in automatic in-service. The
•
port service state changes to Out-Of-Service and
Autonomous, Automatic In-Service (OOS-AU,AINS).
OOS,DSBLD—Removes the port from service and
•
disables it. The port service state changes to
Out-of-Service and Management, Disabled
(OOS-MA,DSBLD).
• OOS,MT—Removes the port from service for
maintenance. The port service state changes to
Out-of-Service and Management, Maintenance
(OOS-MA,MT).
IS-NR—The port is fully operational and performing
•
as provisioned.
OOS-AU,AINS—The port is out-of-service, but traffic
•
is carried. Alarm reporting is suppressed. The ONS
node monitors the ports for an error-free signal. After
an error-free signal is detected, the port stays in
OOS-AU,AINS state for the duration of the soak
period. After the soak period ends, the port service
state changes to IS-NR.
• OOS-MA,DSBLD—The port is out-of-service and
unable to carry traffic.
• OOS-MA,MT—The port is out-of-service for
maintenance. Alarm reporting is suppressed, but traffic
is carried and loopbacks are allowed.
• Duration of valid input signal, in hh.mm format, after
which the card becomes in service (IS) automatically
• 0 to 48 hours, 15-minute increments
Options
1 to 12
Numeric. Can be set for 15-minute or one-day intervals.
Select the bullet and click the Show Thresholds button.
Cisco ONS 15454 Procedure Guide, R5.0
22-23