Figure 5-6 Path Protection Fiber Connection Example; Ntp- A44 Provision Path Protection Nodes - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:

Table of Contents

Turn Up Network

Verify that the fiber is correctly connected to the path protection trunk (span) OC-N cards similar to

Log into an ONS 15454 in the path protection you are turning up. See the

task on page

Complete the

cards/ports that will serve as the path protection ports on the node, for example, Slot 5 (OC-48)/Node 1

and Slot 12 (OC-48)/Node 1. (Alternatively, if additional bandwidth is needed for CTC management,

complete the

Repeat Steps

As needed, complete the

As needed, complete the

As needed, complete the

Complete the

Stop. You have completed this procedure.

December 2004

5-6. See the

"DLP-A43 Install Fiber-Optic Cables for Path Protection Configurations" task on

Path Protection Fiber Connection Example

17-66. If you are already logged in, continue with Step 3.

"DLP-A377 Provision Section DCC Terminations" task on page 20-61

"DLP-A378 Provision Line DCC Terminations" task on page

If an ONS 15454 is not connected to a corporate LAN, DCC or LDCC provisioning must be

performed through a direct (craft) connection. Remote provisioning is possible only after all

nodes in the network have DCC or LDCC terminations provisioned to in-service OC-N ports.

for each node in the path protection.

"DLP-A380 Provision a Proxy Tunnel" task on page

"DLP-A381 Provision a Firewall Tunnel" task on page

"DLP-A367 Create a Provisionable Patchcord" task on page

"NTP-A177 Path Protection Acceptance Test" procedure on page

NTP-A44 Provision Path Protection Nodes

"DLP-A60 Log into CTC"

Cisco ONS 15454 Procedure Guide, R5.0

or for the two

Chapters

Table of Contents