Ntp- A305 Provision Ce-100T-8 Pos Ports - Cisco ONS 15454 Series Procedure Manual

NTP-A305 Provision CE-100T-8 POS Ports
Note
Stop. You have completed this procedure.
NTP-A305 Provision CE-100T-8 POS Ports
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note You can provision SONET CCAT or VCAT circuits for the CE-100T-8 before or after provisioning the
card's Ethernet ports and/or POS ports. Refer to the
Circuit" procedure on page 6-38
procedure on page
Complete the
Step 1
ports.
In the node view, double-click the CE-100T-8 card graphic to open the card.
Step 2
Step 3 Click the Provisioning > POS Ports tabs.
Step 4 For each CE-100T-8 port, provision the following parameters:
•
•
•
•
Note
Note
Cisco ONS 15454 Procedure Guide, R5.0
6-84
Reprovisioning an Ethernet port on the CE-100T-8 card does not reset the Ethernet statistics for
that port.
This procedure provisions CE-100T-8 POS ports to carry traffic.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
6-86, as needed.
"DLP-A60 Log into CTC" task on page 17-66
Port Name—If you want to label the port, enter the port name.
Admin State—Choose IS to put the port in service.
Framing Type— Choose GPF-F POS framing (the default) or HDLC POS framing. The framing
type needs to match the framing type of the POS device at the end of the SONET circuit.
Encap CRC—With GFP-F framing, the user can configure a 32-bit CRC (the default) or none (no
CRC). HDLC framing provides a set 32-bit CRC. The CRC should be set to match the CRC of the
POS device on the end of the SONET circuit.
For more details on the interoperabilty of ONS Ethernet cards, including information on
encapsulation, framing and CRC, refer to the "POS on ONS Ethernet Cards" chapter of the
Ethernet Card Software Feature and Configuration Guide for the Cisco ONS 15454, Cisco ONS
15454 SDH, and Cisco ONS 15327.
The CE-100T-8 uses LEX encapsulation, which is the primary POS encapsulation used in ONS
Ethernet cards.
"NTP-A257 Create an Automatically Routed OC-N
or the "NTP-A264 Create an Automatically Routed VCAT Circuit"
Chapter 6 Create Circuits and VT Tunnels
at the node where you will provision the
August 2005