Dlp- A194 Clear A Blsr Force Ring Switch - Cisco ONS 15454 Series Procedure Manual

DLP-A194 Clear a BLSR Force Ring Switch
On the shelf graphic in CTC, right-click the card that you want to remove and choose Delete Card.
Step 1
You cannot delete a card if any of the following conditions apply:
•
•
•
•
•
•
Return to your originating procedure (NTP).
Step 2
DLP-A194 Clear a BLSR Force Ring Switch
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Provisioning > BLSR tabs.
Step 2
Click Edit.
Step 3
To clear a Force switch on the west line:
Step 4
a.
b.
c.
Cisco ONS 15454 Procedure Guide, R5.0
18-66
The card is a TCC2/TCC2P card. To replace a TCC2/TCC2P card, refer to the
Cisco ONS 15454 Troubleshooting Guide.
The card is part of a protection group; see the
page 18-23.
The card has circuits; see the
page 9-4 and the "DLP-A333 Delete Circuits" task on page
The card is part of a BLSR; see the
The card is being used for timing; see the
page 18-24.
The card has a DCC/GCC termination; see the
Channel Terminations and Provisionable Patchcords" procedure on page
If you delete a card in CTC but do not remove it from the shelf, it will reboot and reappear
Note
in CTC.
This task removes a Force switch from a BLSR port.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite
Maintenance or higher
Right-click the BLSR west port where you want to clear the protection switch and choose
Set West Protection Operation. Ports with a Force switch applied are marked with an F.
In the Set West Protection Operation dialog box, choose CLEAR from the drop-down list. Click
OK.
In the Confirm BLSR Operation dialog box, click Yes.
"DLP-A155 Delete a Protection Group" task on
"NTP-A278 Modify and Delete Overhead Circuits" procedure on
"NTP-A240 Remove a BLSR Node" procedure on page
"DLP-A157 Change the Node Timing Source" task on
"NTP-A292 Modify or Delete Communications
Chapter 18 DLPs A100 to A199
20-21.
10-4.
14-6.
March 2007