Figure 1-3 Installing Standoffs And The Aep; Figure 1-4 Aep Wire-Wrap Connections To Backplane Pins - Cisco ONS 15454 Series Procedure Manual

NTP-A119 Install the Alarm Expansion Panel
Figure 1-3
Insert and tighten three screws to secure the AEP to the backplane.
Step 4
Connect the AEP cable to the backplane and AEP:
Step 5
Connect the 10 colored wires to the wire-wrap pins on the backplane.
a.
cable wires are connected.
Plug the other end of the AEP cable into AEP connector port. The brown pin is on the top.
b.
Figure 1-4
Cisco ONS 15454 Procedure Guide, R5.0
1-14
Installing Standoffs and the AEP
Wires
AEP cable
Connector
Table 1-1
AEP Wire-Wrap Connections to Backplane Pins
White
Black
A B A B A B
1 1 1 1
2 2 2 2
3 3 3 3
4 4 4 4
BITS LAN
IN
FG1 FG2 FG3 FG4
Violet
Slate
shows AEP and AIC-I signals that each wire carries.
Orange
Yellow
A B A B A B
7 1
ACO
8 2
5 9 3
6 10 4
ENVIRONMENTAL ALARMS
IN
IN/OUT IN
FG5 FG6 FG7
Green Brown
Blue Red
Chapter 1 Install the Shelf and Backplane Cable
Figure 1-4 shows where the
A B A A B A
1 1 1
2 2 2
3 3 3
4 4 4
MODEM CRAFT LOCAL ALARMS
VIS AUD
FG8 FG9 FG10
B A B
11
12
IN
FG11 FG12
March 2005