Static Ip Addresses - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

DLP-A50 Set Up a Windows PC for Craft Connection to an ONS 15454 on the Same Subnet Using Static IP Addresses
DLP-A50 Set Up a Windows PC for Craft Connection to an ONS 15454 on the
Same Subnet Using Static IP Addresses
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1
Verify the operating system that is installed on your computer:
a.
b.
c.
According to the Windows operating system installed on your computer, perform one of the following
Step 2
steps:
If you have Windows 98 installed on your PC, complete the following steps to change its TCP/IP
Step 3
configuration:
a.
b.
c.
d.
e.
f.
g.
Cisco ONS 15454 Procedure Guide, R5.0
17-56
This task sets up your computer for a local craft connection to the
ONS 15454 when:
None
NTP-A260 Set Up Computer for CTC, page 3-1
As needed
Onsite
None
From the Windows Start menu, choose Settings > Control Panel.
In the Control Panel window, double-click the System icon.
On the General tab of the System Settings window, verify that the Windows operating system is one
of the following: Windows 98, Windows NT 4.0, Windows 2000, or Windows XP.
For Windows 98, complete
For Windows NT 4.0, complete
For Windows 2000, complete
For Windows XP, complete
From the Windows Start menu, choose Settings > Control Panel.
In the Control Panel dialog box, click the Network icon.
In the Network dialog box, choose TCP/IP for your network interface card (NIC), then click
Properties.
In the TCP/IP Properties dialog box, click the DNS Configuration tab and choose Disable DNS.
Click the WINS Configuration tab and choose Disable WINS Resolution.
Click the IP Address tab.
In the IP Address window, click Specify an IP address.
You will access nodes running software releases earlier than Software
Release 3.3.
You will connect to one ONS 15454; if you will connect to multiple
ONS 15454s, you might need to reconfigure your computer's IP
settings each time you connect to an ONS 15454.
You need to use non-ONS 15454 applications such as ping and tracert
(trace route).
Step
3.
Step
4.
Step
5.
Step
6.
Chapter 17
DLPs A1 to A99
March 2005

Advertisement

Table of Contents
loading

Table of Contents