Dlp- A51 Set Up A Windows Pc For Craft Connection To An Ons 15454 Using Dynamic Host Configuration Protocol - Cisco ONS 15454 Series Procedure Manual

DLP-A51 Set Up a Windows PC for Craft Connection to an ONS 15454 Using Dynamic Host Configuration Protocol
h.
i.
j.
If you have Windows XP installed on your PC, complete the following steps to change its TCP/IP
Step 6
configuration:
a.
b.
c.
d.
e.
f.
g.
h.
i.
Return to your originating procedure (NTP).
Step 7
DLP-A51 Set Up a Windows PC for Craft Connection to an ONS 15454 Using
Dynamic Host Configuration Protocol
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Do not use this task for initial node turn-up. Use the task only if DHCP forwarding is enabled on the
Note
ONS 15454. By default, DHCP is not enabled. To enable it, see the
Access" procedure on page
Cisco ONS 15454 Procedure Guide, R5.0
17-58
Click OK.
In the Local Area Connection Properties dialog box, click OK.
In the Local Area Connection Status dialog box, click Close.
From the Windows Start menu, choose Control Panel > Network Connections.
Note If the Network Connections menu item is not available, click Switch to Classic View.
From the Network Connections dialog box, click the Local Area Connection icon.
From the Local Area Connection Properties dialog box, choose Internet Protocol (TCP/IP), then
click Properties.
In the IP Address field, enter an IP address that is identical to the ONS 15454 IP address except for
the last octet. The last octet must be 1 or 3 through 254. This IP address appears on the LCD unless
its display is suppressed during node provisioning.
In the Subnet Mask field, type 255.255.255.0.
In the Default Gateway field, type the ONS 15454 IP address.
Click OK.
In the Local Area Connection Properties dialog box, click OK.
In the Local Area Connection Status dialog box, click Close.
This task sets up your computer for craft connection to the ONS 15454
using Dynamic Host Configuration Protocol (DHCP).
None
NTP-A260 Set Up Computer for CTC, page 3-1
NTP-A169 Set Up CTC Network Access, page 4-7
As needed
Onsite
None
4-7.
Chapter 17 DLPs A1 to A99
"NTP-A169 Set Up CTC Network
March 2005