Before You Begin - Cisco ONS 15454 Series Procedure Manual

Chapter 5 Turn Up Network
•
•
Click the Provisioning > General tabs. Verify that all general node information settings match the
Step 4
settings of your site plan. If not, see the
on page
Step 5 Click the Provisioning > Timing tabs. Verify that timing settings match the settings of your site plan.
If not, see the
Step 6 Click the Provisioning > Network tabs. Ensure that the IP settings and other CTC network access
information is correct. If not, see the
page
Click the Provisioning > Protection tabs. Verify that all protection groups have been created according
Step 7
to your site plan. If not, see the
page
Click the Provisioning > Security tabs. Verify that all users have been created and their security levels
Step 8
and policies match the settings indicated by your site plan. If not, see the
Change Security" procedure on page
If Simple Network Management Protocol (SNMP) is provisioned on the node, click the Provisioning >
Step 9
SNMP tabs. Verify that all SNMP settings match the settings of your site plan. If not, see the
Change SNMP Settings" procedure on page
Provision the network using the applicable procedure shown in the
Step 10
page
Stop. You have completed this procedure.
NTP-A124 Provision a Point-to-Point Network
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
want to provision a point-to-point configuration. If you are already logged in, continue with Step 2.
Click the Provisioning > Protection tabs. Verify that 1+1 protection is created for the OC-N cards.
Step 2
Complete the
created.
Step 3 Repeat Steps
December 2004
If the software is not the correct version, install the correct version from the ONS 15454 software
CD. Upgrade procedures are located in a release-specific software upgrade document.
TCC2/TCC2P cards can also be ordered with the latest software release.
If the node defaults are not correct, import the network element defaults. Refer to the "Network
Element Defaults" appendix in the Cisco ONS 15454 Reference Manual.
10-2.
"NTP-A85 Change Node Timing" procedure on page
10-2.
10-4.
5-1.
This procedure provisions two ONS 15454s in a 1+1 point-to-point
(terminal) network.
None
NTP-A35 Verify Node Turn-Up, page 5-2
As needed
Onsite
Provisioning and higher
"DLP-A60 Log into CTC" task on page 17-66
"DLP-A73 Create a 1+1 Protection Group" task on page 17-81
1 and 2 for the second point-to-point node.
"NTP-A81 Change Node Management Information" procedure
"NTP-A201 Change CTC Network Access" procedure on
"NTP-A203 Modify or Delete Card Protection Settings" procedure on
10-6.
10-6.
NTP-A124 Provision a Point-to-Point Network
10-5.
"NTP-A205 Modify Users and
"Before You Begin" section on
on an ONS 15454 in the network where you
if protection has not been
Cisco ONS 15454 Procedure Guide, R5.0
"NTP-A87
5-3