Dlp- A189 Verify That A 1+1 Working Slot Is Active - Cisco ONS 15454 Series Procedure Manual

DLP-A189 Verify that a 1+1 Working Slot is Active
Verify that the card boots up properly.
Step 14
Click the Inventory tab and verify that the new card appears as a DS3N-12E.
Step 15
Click the Provisioning > Protection tabs.
Step 16
Click Create.
Step 17
Type a name for the protection group in the Name field (optional).
Step 18
Click Type and choose 1:N (card) from the drop-down list.
Step 19
Verify that the DS3N-12E card appears in the Protect Card field.
Step 20
In the Available Cards list, highlight the cards that you want in the protection group. Click the arrow
Step 21
(>>) button to move the cards to the Working Cards list.
Click OK.
Step 22
The protection group should appear in the Protection Groups list on the Protection subtab.
Return to your originating procedure (NTP).
Step 23
DLP-A189 Verify that a 1+1 Working Slot is Active
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In node view, click the Maintenance > Protection tabs.
Step 1
In the Selected Group area, verify that the working slot/port is shown as Working/Active. If so, this task
Step 2
is complete.
If the working slot says Working/Standby, perform a Manual switch on the working slot:
Step 3
a.
a.
b.
Verify that the working slot is carrying traffic (Working/Active).
Step 4
Note
When the working slot is carrying traffic, clear the Manual switch:
Step 5
a.
b.
Cisco ONS 15454 Procedure Guide, R5.0
18-60
This task verifies that a working slot in a 1+1 protection scheme is active
(and that the protect slot is in standby).
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Maintenance or higher
In the Selected Group area, choose the Protect/Active slot.
In the Switch Commands field, choose Manual.
Click Yes in the confirmation dialog box.
If the slot is not active, look for conditions or alarms that might be preventing the card from
carrying working traffic. Refer to the Cisco ONS 15454 Troubleshooting Guide.
In the Switch Commands field, choose Clear.
Click Yes in the confirmation dialog box.
Chapter 18 DLPs A100 to A199
March 2007