Before You Begin - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

Add and Remove Nodes
The terms "Unidirectional Path Switched Ring" and "UPSR" may appear in Cisco literature. These terms
Note
do not refer to using Cisco ONS 15xxx products in a unidirectional path switched ring configuration.
Rather, these terms, as well as "Path Protected Mesh Network" and "PPMN," refer generally to Cisco's
path protection feature, which may be used in any topological network configuration. Cisco does not
recommend using its path protection feature in any particular topological network configuration.
This chapter explains how to add and remove Cisco ONS 15454 nodes from bidirectional line switched
rings (BLSRs), path protection configurations, and linear add-drop multiplexer (ADM) networks.

Before You Begin

Before performing any of the following procedures, complete the
and Network Provisioning" procedure on page
conditions. Refer to the Cisco ONS 15454 Troubleshooting Guide as necessary.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
December 2004
NTP-A212 Add a BLSR Node, page
NTP-A240 Remove a BLSR Node, page
NTP-A105 Add a Path Protection Node, page
NTP-A294 Remove a Path Protection Node, page
NTP-A262 Add a Node to a Linear ADM, page
end of a linear ADM. This procedure can be used to add a node between two linear ADM nodes, but
requires that circuits be deleted and recreated. To add a node without disrupting traffic, use the
following procedure.
NTP-A312 Add a Node to a Linear ADM Using the Wizard, page
add a node between two linear ADM nodes.
NTP-A313 Remove an In-Service Node from a Linear ADM, page
remove a node from a linear ADM without disrupting traffic.
C H A P T E R
"NTP-A195 Document Card, Node,
7-2. Also investigate all alarms and clear any trouble
14-2—Complete as needed.
14-6—Complete as needed.
14-9—Complete as needed.
14-11—Complete as needed.
14-13—Complete as needed to add a node to the
Cisco ONS 15454 Procedure Guide, R5.0
14
14-14—Complete as needed to
14-17—Complete as needed to
14-1

Advertisement

Table of Contents
loading

Table of Contents