Before You Begin - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

Turn Up Node
This chapter explains how to provision a single Cisco ONS 15454 node and turn it up for service,
including assigning a node name, date and time, timing references, network attributes such as IP address
and default router, users and user security, and card protection groups.

Before You Begin

Complete the procedures applicable to your site plan from the following chapters:
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
8.
9.
December 2004
Chapter 1, "Install the Shelf and Backplane Cable"
Chapter 2, "Install Cards and Fiber-Optic Cable"
Chapter 3, "Connect the PC and Log into the GUI"
NTP-A24 Verify Card Installation, page
NTP-A30 Create Users and Assign Security, page
Cisco Transport Controller (CTC) users and assign their security levels.
NTP-A25 Set Up Name, Date, Time, and Contact Information, page
procedure to set the node name, date, time, location, and contact information.
NTP-A261 Set Power Monitor Thresholds, page
battery power thresholds.
NTP-A169 Set Up CTC Network Access, page
IP address, default router, subnet mask, and network configuration settings.
NTP-A27 Set Up the ONS 15454 for Firewall Access, page
the ONS 15454 will be accessed behind firewalls.
NTP-A28 Set Up Timing, page
timing references.
NTP-A170 Create Protection Groups, page
1:N, 1+1, or Y-cable protection groups for ONS 15454 electrical and optical cards.
NTP-A256 Set Up SNMP, page
Protocol (SNMP) will be used for network monitoring.
C H A P T E R
4-2—Complete this procedure first.
4-4—Complete this procedure to create
4-6—Continue with this procedure to set the node
4-7—Continue with this procedure to provision the
4-9—Continue with this procedure to set up the node's SONET
4-10—Complete this procedure, as needed, to set up 1:1,
4-12—Complete this procedure if Simple Network Management
Cisco ONS 15454 Procedure Guide, R5.0
4-4—Continue with this
4-8—Continue with this procedure if
4
4-1

Advertisement

Table of Contents
loading

Table of Contents