Dlp- A374 Change A Section Dcc Termination - Cisco ONS 15454 Series Procedure Manual

DLP-A374 Change a Section DCC Termination
DLP-A374 Change a Section DCC Termination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the Provisioning > Comm Channels > SDCC tabs.
Step 1
Step 2 Click the SDCC that you want to change.
Click Edit.
Step 3
In the SDCC Termination Editor dialog box, complete the following as necessary:
Step 4
•
•
•
Click OK.
Step 5
Return to your origination procedure (NTP).
Step 6
DLP-A375 Change a Line DCC Termination
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Click the Provisioning > Comm Channels > LDCC tabs.
Step 1
Click the LDCC that you want to change.
Step 2
Click Edit.
Step 3
In the LDCC Termination Editor dialog box, complete the following as necessary:
Step 4
•
Cisco ONS 15454 Procedure Guide, R5.0
20-60
This task modifies an SDCC. You can enable or disable Open Shortest Path
First (OSPF) and enable or disable the foreign node setting.
None
DLP-A60 Log into CTC, page 17-66
As needed
Remote
Provisioning or higher
Disable OSPF on SDCC Link—If checked, OSPF is disabled on the link. OSPF should be disabled
only when the slot and port connect to third-party equipment that does not support OSPF.
Far End is Foreign—Check this box to specify that the SDCC termination is a non-ONS node.
Far End IP—If you checked the Far End is Foreign check box, type the IP address of the far-end
node or leave the 0.0.0.0 default. An IP address of 0.0.0.0 means that any address can be used by the
far end.
This task modifies an LDCC. You can enable or disable OSPF and enable
or disable the foreign node setting.
None
DLP-A60 Log into CTC, page 17-66
As needed
Remote
Provisioning or higher
Disable OSPF on LDCC Link—If checked, OSPF is disabled on the link. OSPF should be disabled
only when the slot and port connect to third-party equipment that does not support OSPF.
Chapter 20 DLPs A300 to A399
March 2005