Chapter 21
DLPs A400 to A499
Table 21-3
Parameter
Admin State
Service State
Port Rate
Link Rate
Max GBIC
Rate
Link Recovery Enables or disables link recovery if a
Media Type
Step 4
Click Apply.
March 2005
FC_MR-4 Card General Port Settings (continued)
Description
Changes the port service state unless
network conditions prevent the change.
Identifies the autonomously generated
state that gives the overall condition of
the port. Service states appear in the
format: Primary State-Primary State
Qualifier, Secondary State.
Selects the Fibre Channel interface.
Displays the actual rate of the port.
Displays the maximum Gigabit Interface
Converter (GBIC) rate. Cisco supports
two GBICs for the FC_MR-4 card
(ONS-GX-2FC-SML and
ONS-GX-2FC-MMI). If used with
another GBIC, "Contact GBIC vendor" is
displayed.
local port is inoperable. If enabled, a link
reset occurs when there is a loss of
transport from a cross-connect switch,
protection switch, or an upgrade.
Sets the proper payload value for the
Transparent Generic Framing Protocol
(GFP-T) frames.
DLP-A438 Change General Port Settings for the FC_MR-4 Card
Options
IS—Puts the port in-service. The port
•
service state changes to IS-NR.
OOS,DSBLD—Removes the port
•
from service and disables it. The port
service state changes to
OOS-MA,DSBLD.
OOS,MT—Removes the port from
•
service for maintenance. The port
service state changes to
OOS-MA,MT.
IS-NR—(In-Service and Normal)
•
The port is fully operational and
performing as provisioned.
•
OOS-MA,DSBLD—(Out-of-Service
and Management,Disabled) The port
is out-of-service and unable to carry
traffic.
OOS-MA,MT—(Out-of-Service and
•
Management,Maintenance) The port
is out-of-service for maintenance.
Alarm reporting is suppressed, but
traffic is carried and loopbacks are
allowed.
1 Gbps
•
2 Gbps
•
—
—
—
•
Fibre Channel - 1 Gbps
Fibre Channel - 2 Gbps
•
FICON 1 Gbps
•
FICON 2 Gbps
•
Unknown
•
Cisco ONS 15454 Procedure Guide, R5.0
21-17