Cisco ONS 15454 Series Procedure Manual page 315

Chapter 12 Upgrade Cards and Spans
Note
In node view, click the Maintenance > Cross-Connect tabs.
Step 5
From the Cross Connect Cards menu, choose Switch.
Step 6
Click Yes on the Confirm Switch dialog box. Traffic switches to the XC10G card you inserted in
Step 7
Step
Physically remove the now standby XCVT card from the ONS 15454 and insert the second XC10G card
Step 8
into the empty XCVT card slot:
a.
b.
c.
d.
e.
The upgrade is complete when the second XC10G card boots up and becomes the standby XC10G card.
In node view, both the active and standby cards will change to XC10G.
Stop. You have completed this procedure.
NTP-A296 Upgrade the TCC2 Card to the TCC2P Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
The TCC2P card does not support software earlier than R4.0. You will not be able to revert to a software
Note
release earlier than Software R4.0 with TCC2P cards installed.
Downgrade procedures from TCC2P cards to TCC2 cards are not supported. Contact Cisco Technical
Note
Assistance Center (TAC) for more information see the
and Security Guidelines" section on page
January 2005
On the XC10G card the fail LED above the ACT/STBY LED becomes red, blinks for several
seconds, and turns off. The ACT/STBY LED turns amber and remains on. In node view, the
XC10G appears as the standby XCVT.
4. The ACT/STBY LED on this card changes from amber to green.
Open the XCVT card ejectors.
Slide the XCVT card out of the slot.
Open the ejectors on the XC10G card.
Slide the XC10G card into the slot along the guide rails.
Close the ejectors.
This procedure upgrades the TCC2 card to the TCC2P card. The TCC2
and TCC2P cards support ONS 15454 Software R4.0 and later software
versions.
Two SONET TCC2P cards
Two TCC2 cards
None
As needed
Onsite
Maintenance or higher
NTP-A296 Upgrade the TCC2 Card to the TCC2P Card
"Obtaining Documentation, Obtaining Support,
lvi.
Cisco ONS 15454 Procedure Guide, R5.0
12-3