Dlp- A64 Set The Ip Address, Default Router, And Network Mask Using The Lcd - Cisco ONS 15454 Series Procedure Manual

Chapter 17 DLPs A1 to A99
Note
Click OK.
Step 4
After a few seconds, the new node appears on the network view map.
Return to your originating procedure (NTP).
Step 5
DLP-A64 Set the IP Address, Default Router, and Network Mask Using the LCD
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
You cannot perform this task if the LCD IP Display on the node view Provisioning > Network tab is set
Note
to Display Only or Suppress Display. See
or change the LCD IP Display field.
The LCD reverts to normal display mode after 5 seconds of button inactivity.
Note
Step 1 On the ONS 15454 front panel, repeatedly press the Slot button until Node appears on the LCD.
Step 2 Repeatedly press the Port button until the following displays:
•
•
•
Figure 17-28
Press the Status button to display the node IP address
Step 3
the default router IP address.
March 2005
This check box is active only if you selected a login group when you logged into CTC.
This task changes the ONS 15454 IP address, default router, and network
mask using the LCD on the fan-tray assembly. Use this task if you cannot
log into CTC.
None
DLP-A36 Install the TCC2/TCC2P Cards, page 17-42
Optional
Onsite
None
To change the node IP address, Status=IpAddress
To change the node network mask, Status=Net Mask
To change the default router IP address, Status=Default Rtr
Selecting the IP Address Option
Slot Status
FAN FAIL CRIT MAJ
DLP-A64 Set the IP Address, Default Router, and Network Mask Using the LCD
"DLP-A249 Provision IP Settings" task on page 19-30
(Figure
Port
Slot-0
Status=IpAddress
MIN
(Figure
17-28)
17-29), the node subnet mask length, or
Cisco ONS 15454 Procedure Guide, R5.0
to view
17-71