Ntp- A90 Modify Alarm Interface Controller Settings - Cisco ONS 15454 Series Procedure Manual

Chapter 11 Change Card Settings
Complete the
Step 1
OC-N card settings. If you are already logged in, proceed to
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.
NTP-A90 Modify Alarm Interface Controller Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
AIC card settings. If you are already logged in, proceed to
Complete the
Step 2
Perform any of the following tasks as needed:
Step 3
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.
December 2004
"DLP-A60 Log into CTC" task on page 17-66
"NTP-A108 Back Up the Database" procedure on page
DLP-A170 Change Line Transmission Settings for OC-N Cards, page 18-49
DLP-A171 Change Threshold Settings for OC-N Cards, page 18-51
DLP-A172 Change an Optical Port to SDH, page 18-53
"NTP-A108 Back Up the Database" procedure on page
This procedure provisions the AIC card to receive input from, or send
output to, external devices wired to the backplane (called external alarms
and controls or environmental alarms) and changes orderwire settings.
None
NTP-A32 Provision External Alarms and Controls on the Alarm Interface
Controller, page 7-9
DLP-A83 Provision Orderwire, page 17-84
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"NTP-A108 Back Up the Database" procedure on page
DLP-A173 Change External Alarms Using the AIC Card, page 18-54
DLP-A174 Change External Controls Using the AIC Card, page 18-54
DLP-A175 Change Orderwire Settings Using the AIC Card, page 18-55
"NTP-A108 Back Up the Database" procedure on page
NTP-A90 Modify Alarm Interface Controller Settings
at the node where you want to change the
Step 2.
15-4.
15-4.
at the node where you want to change the
Step 2.
15-4.
15-4.
Cisco ONS 15454 Procedure Guide, R5.0
11-3