Ntp- A239 View E-Series Ethernet Maintenance Information - Cisco ONS 15454 Series Procedure Manual

Chapter 15 Maintain the Node
To view loopback status, click the Maintenance > Loopback tabs.
Step 3
The Port and Service State columns identify the port number and current service state (In-Service and
Normal [IS-NR], Out-of-Service and Management, Disabled [OOS-MA,DSBLD], or Out-of-Service and
Management, Maintenance [OOS-MA,MT]) for each port. The Loopback Type column identifies the
type of loopback (None, Terminal [Inward], or Facility [Line]) applied to each port on the card.
To view Ethernet bandwidth utilization, click the Maintenance > Bandwidth tabs.
Step 4
Click Retrieve Bandwidth Usage.
Step 5
The current STS bandwidth usage information appears.
To view J1 path trace information, click the Maintenance > Path Trace tabs and then click Retrieve.
Step 6
Stop. You have completed this procedure.
NTP-A239 View E-Series Ethernet Maintenance Information
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note The E-Series Maintenance tab is not implemented in this release.
Complete the
Step 1
Step
To view spanning tree information, in node view click the Maintenance > Ether Bridge >
Step 2
Spanning Trees tabs.
As needed, complete the following tasks:
Step 3
•
•
Stop. You have completed this procedure.
December 2004
"DLP-A60 Log into CTC" task on page
2.
DLP-A309 View the Ethernet MAC Address Table, page 20-4
DLP-A310 View Ethernet Trunk Utilization, page 20-5
NTP-A239 View E-Series Ethernet Maintenance Information
This procedure enables you to view maintenance information for
E-Series Ethernet cards.
None
NTP-A246 Install Ethernet Cards and Connectors, page 2-10
As needed
Onsite or remote
Retrieve or higher
17-66. If you are already logged in, continue with
Cisco ONS 15454 Procedure Guide, R5.0
15-17