Table 2-3 Oc-N Card Transmit And Receive Levels - Cisco ONS 15454 Series Procedure Manual

NTP-A247 Install Fiber-Optic Cables on OC-N Cards
Table 2-3
Card
OC48 IR 1310
OC48 LR 1550
OC48 IR/STM16 SH AS 1310
OC48 LR/STM16 LH AS 1550
OC48 ELR/STM16 EH 100 GHz
OC48 ELR/STM16 EH 200 GHz
OC192 SR/STM64 IO 1310
OC192 IR/STM64 SH 1550
OC192 LR/STM64 LH 1550
OC192 LR/STM64 LH ITU 15xx.xx +3 dBm
Step 2 Inspect and clean all fiber connectors thoroughly. See the
procedure on page 15-13
connectors that are not used.
As needed, complete the
Step 3
page 19-5.
As needed, complete the
Step 4
page 21-8.
Note
As needed, complete the
Step 5
on page
As needed, complete the
Step 6
page 17-52.
As needed, complete the
Step 7
Continue with the
Step 8
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
2-16
OC-N Card Transmit and Receive Levels (continued)
for instructions. Dust particles can degrade performance. Put caps on any fiber
"DLP-A207 Install Fiber-Optic Cables on the LGX Interface" task on
"DLP-A428 Install Fiber-Optic Cables in a 1+1 Configuration" task on
To install fiber-optic cables on Ethernet cards, FC_MR-4 cards, or transponder/muxponder
cards, see the "DLP-A469 Install GBIC or SFP Connectors" task on page
"DLP-A43 Install Fiber-Optic Cables for Path Protection Configurations" task
17-49.
"DLP-A44 Install Fiber-Optic Cables for BLSR Configurations" task on
"DLP-A45 Install the Fiber Boot" task on page
"NTP-A245 Route Fiber-Optic Cables" procedure on page
Chapter 2
Transmit Receive
Minimum Maximum Minimum
–5 dBm 0 dBm –18 dBm
–2 dBm +3 dBm –28 dBm
–5 dBm 0 dBm –18 dBm
–2 dBm +3 dBm –28 dBm
–2 dBm 0 dBm –27 dBm at
1E-12 BER
–2 dBm 0 dBm –28 dBm
–6 dBm –1 dBm –11 dBm
–1 dBm +2 dBm –14 dBm
+7 dBm +10 dBm –19 dBm
+6 dBm –22 dBm
"NTP-A112 Clean Fiber Connectors"
Install Cards and Fiber-Optic Cable
Maximum
0 dBm
–8 dBm
0 dBm
–8 dBm
–9 dBm
–8 dBm
–1 dBm
–1 dBm
–10 dBm
–9 dBm
21-24.
17-54.
2-17.
May 2006