Chapter 16 Power Down The Node - Cisco ONS 15454 Series Procedure Manual

NTP-A114 Power Down the Node
Verify that the node is not connected to a network.
Step 3
If the node is part of a working network, log out of the node and complete the
a.
an In-Service Node from a Linear ADM" procedure on page
BLSR Node" procedure on page
procedure on page
(MSTP) configuration, consult your network administrator. Continue with
b. If the node is not connected to a working network and the current configurations are no longer
required, proceed to
Note
In node view, click the Circuits tab and verify that no circuits are displayed, then proceed to
Step 4
circuits are displayed, delete all the circuits that originate or terminate in the node, as follows:
When deleting circuits from a node, make sure that the node is not connected to any network.
Note
Click the circuits that need to be deleted and click Delete.
a.
Click Yes.
b.
Repeat until no circuits are displayed.
In node view, click the Provisioning > Protection tabs and delete all protection groups:
Step 5
Click the protection group that needs to be deleted and click Delete.
a.
b. Click Yes.
Repeat until no protection groups are displayed.
Step 6 In node view, click the Provisioning > Comm Channels tabs and delete all communications channel
terminations:
Click the section data communications channel (SDCC), line data communications channel
a.
(LDCC), generic communications channel (GCC), or OSC termination that needs to be deleted and
click Delete.
b. Click Yes.
Repeat until no SDCC, LDCC, GCC, or OSC terminations are present.
Note
For each installed OC-N or DS-N card, place all ports in Out-of-Service and Management, Disabled
Step 7
(OOS-MA,DSBLD) service status:
In card view, click the Provisioning > Line tabs.
a.
Click under the Status column for each port and make sure that OOS,DSBLD is selected.
b.
Note
Remove all fiber connections to the cards.
Step 8
Cisco ONS 15454 Procedure Guide, R5.0
16-2
14-11. If the node is part of a Software R5.0 Multiservice Transport Platform
Step 4.
Current configurations will be saved if Steps
Before deleting the OSC termination, make sure the Ring ID is deleted. Click the Provisioning
> Comm Channels > OSC tabs. Select the Ring ID and click Delete.
Refer to ONS 15454 DWDM Installation and Operations Manual for information regarding
DWDM cards.
14-6, or the "NTP-A294 Remove a Path Protection Node"
4 to 13
Chapter 16 Power Down the Node
"NTP-A313 Remove
14-17, the "NTP-A240 Remove a
Step 4.
are skipped.
December 2004
Step 5. If