Ntp- A118 Modify Alarm Interface Controller-International Settings - Cisco ONS 15454 Series Procedure Manual

NTP-A118 Modify Alarm Interface Controller-International Settings
NTP-A118 Modify Alarm Interface Controller-International
Settings
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
AIC-I card settings. If you are already logged in, proceed to
Step 2 Complete the
Perform any of the following tasks as needed:
Step 3
•
•
•
Complete the
Step 4
Stop. You have completed this procedure.
NTP-A91 Upgrade DS-1 and DS-3 Protect Cards from 1:1
Protection to 1:N Protection
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
DS-1 or DS-3 cards from 1:1 to 1:N protection. If you are already logged in, proceed to
Step 2 Complete the
Cisco ONS 15454 Procedure Guide, R5.0
11-4
This procedure provisions the AIC-I card to receive input from or send
output to external devices wired to the backplane (called external alarms
and controls or environmental alarms), or to change orderwire settings.
None
NTP-A258 Provision External Alarms and Controls on the Alarm Interface
Controller-International, page 7-11
DLP-A83 Provision Orderwire, page 17-84
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"NTP-A108 Back Up the Database" procedure on page
DLP-A208 Change External Alarms Using the AIC-I Card, page 19-6
DLP-A209 Change External Controls Using the AIC-I Card, page 19-7
DLP-A210 Change AIC-I Card Orderwire Settings, page 19-8
"NTP-A108 Back Up the Database" procedure on page
This procedure converts DS-1 and DS-3 protect cards from 1:1 to 1:N
protection. This procedure does not apply to DWDM-only nodes.
None
DLP-A71 Create a 1:1 Protection Group, page 17-78
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
"NTP-A108 Back Up the Database" procedure on page
Chapter 11 Change Card Settings
at the node where you want to change the
Step 2.
15-4.
15-4.
at the node where you want to convert the
15-4.
Step 2.
December 2004