Dlp- A422 Verify Blsr Extension Byte Mapping - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

DLP-A422 Verify BLSR Extension Byte Mapping
DLP-A422 Verify BLSR Extension Byte Mapping
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
In network view, double-click a BLSR node with OC-48 AS trunk (span) cards that will be reconnected
Step 1
after a BLSR node removal.
Double-click one OC-48 AS BLSR trunk card.
Step 2
Click the Provisioning > Line tabs.
Step 3
Record on paper the byte in the BLSR Ext Byte column.
Step 4
Repeat Steps
Step 5
Step 6
If the node at the other end of the new span contains OC-48 AS trunk cards, repeat Steps
the node. If it does not have OC-48 AS cards, their trunk cards are mapped to the K3 extension byte.
Continue with
If the trunk cards on each end of the new span are mapped to the same BLSR extension byte, continue
Step 7
with
See the
Return to your originating procedure (NTP).
Step 8
DLP-A428 Install Fiber-Optic Cables in a 1+1 Configuration
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
The Cisco OC-3 IR/STM-1 SH, OC-12 IR/STM-4 SH, and OC-48 IR/STM-16 SH interface optics, all
working at 1310 nm, are optimized for the most widely used SMF-28 fiber, available from many
suppliers.
Cisco ONS 15454 Procedure Guide, R5.0
21-8
This task verifies that the extension byte mapping is the same on BLSR
trunk (span) cards that will be connected after a node is removed from a
BLSR.
OC-48 AS cards must be installed at one or both ends of the BLSR span
that will be connected.
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
2
through
4
for the second OC-48 AS trunk card.
Step
7.
Step
8. If they are not the same, remap the extension byte of the trunk cards at one of the nodes.
"DLP-A89 Remap the K3 Byte" task on page
This task installs fiber-optic cables on optical (OC-N) cards in a 1+1 linear
configuration.
Fiber-optic cables
NTP-A112 Clean Fiber Connectors, page 15-13
Required
Onsite
None
Chapter 21
17-87.
DLPs A400 to A499
1
through
5
at
March 2005

Advertisement

Table of Contents
loading

Table of Contents