Chapter 17
DLPs A1 to A99
Figure 17-14
Return to your originating procedure (NTP).
Step 4
DLP-A24 Install DS-1 AMP Champ Cables on the AMP Champ EIA
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Prepare a 56-wire cable for each DS1-14/DS1N-14 card you will install in the shelf assembly.
Step 1
Connect the male AMP Champ connector on the cable to the female AMP Champ connector on the
Step 2
ONS 15454 backplane.
Use the clips on the male AMP Champ connector to secure the connection.
Step 3
The female connector has grooves on the outside edge for snapping the clips into place.
Table 17-4
EIA.
Note
March 2005
Backplane with an SMB EIA for DS-1 Cables
DS-1 Electrical Interface
Adapter or balun
This task installs the DS-1 AMP Champ cables on the AMP Champ EIA.
Wire wrapper
Twisted-pair cables
DLP-A14 Install the AMP Champ EIA, page 17-16
As needed
Onsite
None
shows the pin assignments for the AMP Champ connectors on the ONS 15454 AMP Champ
In
Table
17-4, the shaded area corresponds to the white/orange binder group. A binder group is
a set of 25 pairs of wires coded with an industry-standard color scheme.
DLP-A24 Install DS-1 AMP Champ Cables on the AMP Champ EIA
Cisco ONS 15454 Procedure Guide, R5.0
17-29