Ntp- A245 Route Fiber-Optic Cables - Cisco ONS 15454 Series Procedure Manual

Chapter 2 Install Cards and Fiber-Optic Cable
NTP-A245 Route Fiber-Optic Cables
Purpose
Tools/Equipment
Prerequisite Procedures Any of the following:
Required/As Needed
Onsite/Remote
Security Level
Open the fold-down front door on the cable-management tray.
Step 1
Route the fiber cable on the card faceplate through the fiber clip on the faceplate, if provided. Fiber clips
Step 2
are factory-attached to the faceplate of OC-N cards.
GBICs do not have fiber clips; therefore, if you are routing fiber from an E1000-2-G, E1000-2,
G1000-2-G, G10002, or FC_MR-4 card, skip to
Route the fiber cables into the cable-management tray.
Step 3
Route the fiber cables out either side of the cable-management tray through the cutouts on each side of
Step 4
the shelf assembly. Use the reversible fiber guides to route cables out the desired side.
Close the fold-down front door when all fiber cables in the front compartment are properly routed.
Step 5
Stop. You have completed this procedure.
NTP-A116 Remove and Replace a Card
Purpose
Tools/Equipment
Prerequisite Procedures A card installation procedure
Required/As Needed
Onsite/Remote
Security Level
Step 1 If you are not logged into CTC and you need to remove a card, remove the card as described in
When you log into CTC, troubleshoot the mismatched equipment alarm (MEA) with the
Cisco ONS 15454 Troubleshooting Guide.
If you are logged into CTC, complete one of the following:
Step 2
•
•
May 2006
This procedure describes how to route fiber-optic cables.
None
NTP-A247 Install Fiber-Optic Cables on OC-N Cards, page 2-14
NTP-A274 Install the FC_MR-4 Cards, page 2-11
As needed
Onsite
None
This procedure removes and replaces all cards housed in the
ONS 15454 shelf and rack.
None
As needed
Onsite
Provisioning or higher
Complete the "DLP-A191 Delete a Card" task on page 18-65
Complete the "DLP-A247 Change an OC-N Card" task on page 19-29
it with a different OC-N card while maintaining existing provisioning.
NTP-A245 Route Fiber-Optic Cables
Step 3.
and continue with
Cisco ONS 15454 Procedure Guide, R5.0
Step 3.
Step 3.
to delete a card and replace
2-17