Ntp- A316 Install The Filler Cards - Cisco ONS 15454 Series Procedure Manual

Chapter 2 Install Cards and Fiber-Optic Cable
•
Complete the
Step 6
FC_MR-4 card.
Note
Step 7 Continue with the
Stop. You have completed this procedure.
NTP-A316 Install the Filler Cards
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Warning Blank faceplates (filler panels) serve three important functions: they prevent exposure to hazardous
voltages and currents inside the chassis; they contain electromagnetic interference (EMI) that might
disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not operate
the system unless all cards, power modules, and faceplates are in place.
Always use the supplied electrostatic discharge (ESD) wristband when working with a powered ONS
Caution
15454. Plug the wristband cable into the ESD jack located on the lower right outside edge of the shelf
assembly and ensure the shelf assembly is properly grounded.
May 2006
The ACT LED turns on green.
If the red FAIL LED does not turn on, check the power.
Note
If you insert a card into a slot provisioned for a different card, all LEDs turn off.
Note
"DLP-A469 Install GBIC or SFP Connectors" task on page 21-24
If you need to remove a GBIC or SFP, complete the
Connectors" task on page
"NTP-A247 Install Fiber-Optic Cables on OC-N Cards" procedure on page
This procedure explains how to install the filler cards (blank faceplates) in
any unused traffic or AIC card slots (Slots 1 through 6, 9, and 11 through
17). The filler card aids in maintaining proper air flow and EMI
requirements.
Filler cards (Cisco P/N 15454-FILLER)
NTP-A15 Install the Common Control Cards, page 2-2
NTP-A16 Install the OC-N Cards, page 2-6
NTP-A17 Install the Electrical Cards, page 2-8
NTP-A246 Install Ethernet Cards and Connectors, page 2-10
NTP-A274 Install the FC_MR-4 Cards, page 2-11
As needed
Onsite
None
21-26.
Cisco ONS 15454 Procedure Guide, R5.0
NTP-A316 Install the Filler Cards
to install GBICs on the
"DLP-A470 Remove GBIC or SFP
2-14.
2-13