Onsite/Remote Security Level; Step 7; None; Prerequisite Procedures - Cisco ONS 15454 Series Procedure Manual

Hide thumbs Also See for ONS 15454 Series:
Table of Contents

Advertisement

DLP-A166 Change Line and Threshold Settings for the DS3-12 or DS3N-12 Cards
Table 18-6
Parameter
SES
UAS
Note
Return to your originating procedure (NTP).

Step 7

DLP-A166 Change Line and Threshold Settings for the DS3-12 or DS3N-12
Cards
Purpose
Tools/Equipment

Prerequisite Procedures

Required/As Needed
Onsite/Remote
Security Level
Double-click the DS3-12 or DS3N-12 card where you want to change the line or threshold settings.
Step 1
Click the Provisioning tab.
Step 2
Depending on the setting you need to modify, click the Line, Line Thresholds, Elect Path Thresholds,
Step 3
or SONET Thresholds tab.
Note
Modify any of the settings found under these subtabs. For definitions of the Line settings, see
Step 4
For definitions of the Line Threshold settings, see
settings, see
Table 18-10 on page
Click Apply.
Step 5
Repeat Steps
Step 6
Table 18-7
Cisco ONS 15454 Procedure Guide, R5.0
18-32
SONET Threshold Options for DS1-14 and DS1N-14 Cards (continued)
Description
Severely errored seconds
Unavailable seconds
The threshold value appears after the circuit is created.
This task changes the line and threshold settings for the DS3-12 or
DS3N-12 (DS-3) cards.

None

DLP-A60 Log into CTC, page 17-66
As needed

Onsite or remote

Provisioning or higher

See
Chapter 7, "Manage Alarms"
Table 18-9 on page
18-35. For definitions of the SONET Threshold settings, see
18-35.
3
through
5
for each subtab that has parameters you want to provision.
describes the values on the Provisioning > Line tabs for the DS-3 cards.
Options
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds (Near End, STS
termination).
Numeric. Can be set for 15-minute or
one-day intervals. Select the bullet and
click Show Thresholds (Near End, STS
termination).
for information about the Alarm Behavior tab.
Table
18-8. For definitions of the Elect Path Threshold
Chapter 18
DLPs A100 to A199
Table
18-7.
March 2007

Advertisement

Table of Contents
loading

Table of Contents