Before You Begin - Cisco ONS 15454 Series Procedure Manual

Change Card Settings
This chapter explains how to change line provisioning, thresholds, and service states on Cisco
ONS 15454 cards.

Before You Begin

Before performing any of the following procedures, investigate all alarms and clear any trouble
conditions. Refer to the Cisco ONS 15454 Troubleshooting Guide as necessary.
Changing card settings can be service affecting. You should make all changes during a scheduled
Caution
maintenance window.
This section lists the chapter procedures (NTPs). Turn to a procedure for applicable tasks (DLPs).
1.
2.
3.
4.
5.
6.
7.
December 2004
NTP-A88 Modify Line Settings and PM Parameter Thresholds for Electrical Cards, page
needed, complete this procedure to change line and threshold settings for all electrical cards (EC-1,
DS-1, DS-3, DS3i-N-12, and DS3XM).
NTP-A89 Modify Line Settings and PM Parameter Thresholds for OC-N Cards, page
needed, complete this procedure to change line and threshold settings for all optical (OC-N) cards.
NTP-A90 Modify Alarm Interface Controller Settings, page
procedure to change external alarms and controls (environmental alarms) and/or orderwire settings.
NTP-A118 Modify Alarm Interface Controller-International Settings, page
complete this procedure to change external alarms and controls and/or orderwire settings.
NTP-A91 Upgrade DS-1 and DS-3 Protect Cards from 1:1 Protection to 1:N Protection, page
11-4—As needed, complete this procedure to change the protection type on DS-1 or DS-3 cards.
NTP-A315 Modify Port Settings and PM Parameter Thresholds for FC_MR-4 Cards, page
needed, complete this procedure to change FC_MR-4 card port and threshold settings.
NTP-A297 Change Card Service State, page
card service state.
C H A P T E R
11-3—As needed, complete this
11-6—As needed, complete this procedure to change
Cisco ONS 15454 Procedure Guide, R5.0
11
11-2—As
11-2—As
11-4—As needed,
11-5—As
11-1