Ntp- A209 Provision An Integrated Blsr/Path Protection Dual-Ring Interconnect - Cisco ONS 15454 Series Procedure Manual

NTP-A209 Provision an Integrated BLSR/Path Protection Dual-Ring Interconnect
NTP-A209 Provision an Integrated BLSR/Path Protection
Dual-Ring Interconnect
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
DRI network. If you are already logged in, continue with Step 2.
Complete the following steps if you have not provisioned the BLSR and path protection that you will
Step 2
interconnect in an integrated DRI. If the BLSR and path protection are created, continue with Step 3.
a.
b.
Verify that the BLSR and path protection DRI interconnect nodes have OC-N cards installed and have
Step 3
fiber connections to the other interconnect node:
•
•
Cisco ONS 15454 Procedure Guide, R5.0
5-30
This procedure provisions a BLSR and a path protection in an integrated
DRI topology.
None
NTP-A35 Verify Node Turn-Up, page 5-2
As needed
Onsite
Provisioning and higher
"DLP-A60 Log into CTC" task on page 17-66
To provision and test the BLSR, complete the following:
"NTP-A40 Provision BLSR Nodes" procedure on page 5-10
•
"NTP-A126 Create a BLSR" procedure on page 5-12
•
"NTP-A175 Two-Fiber BLSR Acceptance Test" procedure on page 5-13
•
"NTP-A176 Four-Fiber BLSR Acceptance Test" procedure on page 5-15
•
To provision and test the path protection, complete the following:
"NTP-A44 Provision Path Protection Nodes" procedure on page 5-20
•
• "NTP-A177 Path Protection Acceptance Test" procedure on page 5-22
The OC-N cards that will connect the BLSR and path protection must be installed at the interconnect
nodes. The OC-N cards in the path protection nodes and the interconnect nodes must be the same
type.
The interconnect nodes must have the correct fiber connections. An example is shown in
Figure 5-10.
Chapter 5
at a node in the BLSR and path protection
Turn Up Network
December 2004