Ntp- A217 Provision An Integrated Path Protection Dual-Ring Interconnect - Cisco ONS 15454 Series Procedure Manual

NTP-A217 Provision an Integrated Path Protection Dual-Ring Interconnect
NTP-A217 Provision an Integrated Path Protection Dual-Ring
Interconnect
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Step 1 Complete the
network. If you are already logged in, continue with Step 2.
Step 2 Complete the following steps if you have not provisioned the path protection configurations that you will
interconnect in a path protection DRI. If the path protection configurations are created, continue with
Step 3.
a.
b.
Note
Step 3 Verify that the path protection DRI interconnect nodes have OC-N cards installed and have fiber
connections to the other interconnect node:
•
•
Cisco ONS 15454 Procedure Guide, R5.0
5-26
This procedure provisions path protection configurations in an integrated
DRI topology. In the integrated DRI, the path protection OC-N trunk cards
for both path protection configurations are installed on the same shelf.
None
NTP-A35 Verify Node Turn-Up, page 5-2
As needed
Onsite
Provisioning and higher
"DLP-A60 Log into CTC" task on page 17-66
Complete the "NTP-A44 Provision Path Protection Nodes" procedure on page 5-20
path protection configurations.
Complete the "NTP-A177 Path Protection Acceptance Test" procedure on page 5-22
protection configurations.
All path protection configurations that will be interconnected must have the same OC-N rate.
The OC-N cards that will connect the path protection configurations must be installed at the
interconnect nodes. The OC-N cards in the path protection nodes and the interconnect nodes must
be the same type.
The interconnect nodes must have the correct fiber connections. An example is shown in
This example shows a path protection DRI with two rings.
Chapter 5
at a node in the path protection DRI
Turn Up Network
to provision the
to test the path
Figure 5-8.
December 2004