Dlp- A517 View Alarm Or Event History - Cisco ONS 15454 Series Procedure Manual

DLP-A517 View Alarm or Event History
Navigate to a directory where you want to store the file.
Step 8
Click OK.
Step 9
Repeat the task for each window that you want to export.
Step 10
Return to your originating procedure (NTP).
Step 11
DLP-A517 View Alarm or Event History
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Decide whether you want to view the alarm message history at the node, network, or card level.
Step 1
To view node alarm history:
Step 2
a.
b.
c.
Tip
Step 3 To view network alarm history from node view:
a.
b.
Cisco ONS 15454 Procedure Guide, R5.0
22-8
This task is used to view previously cleared and uncleared ONS 15454
alarm messages at the card, node, or network level. This task is useful for
troubleshooting configuration, traffic, or connectivity issues that are
indicated by alarms.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Retrieve or higher
Click the History > Session tabs to view the alarms and conditions (events) raised during the current
session.
Click the History > Node tabs.
If you check the Alarms check box, the node's alarm history appears. If you check the Events check
box, the node's Not Alarmed and transient event history appears. If you check both check boxes, you
will retrieve node history for both alarms and events.
Click Retrieve to view all available messages for the History > Node tabs.
Alarms might be unreported if they are filtered out of the display using the Filter button in
Note
either tab. See the
Double-click an alarm in the alarm table or an event (condition) message in the history table to
display the view that corresponds to the alarm message. For example, double-clicking a card
alarm takes you to card view. In network view, double-clicking a node alarm takes you to node
view.
From the View menu, choose Go to Network View.
Click the History tab.
Alarms and conditions (events) raised during the current session appear.
"DLP-A225 Enable Alarm Filtering" task on page 19-17
Chapter 22 DLPs A500 to A599
for information.
October 2005