Ntp- A93 Upgrade The Ds3-12 Card To The Ds3-12E Card - Cisco ONS 15454 Series Procedure Manual

NTP-A93 Upgrade the DS3-12 Card to the DS3-12E Card
According to local site practice, complete the
Step 2
page 15-4.
Determine if the card you are upgrading is protected or unprotected:
Step 3
A protected card will be listed under Protection Groups in the Maintenance > Protection tabs. The
a.
slot, port, and status (that is, Protect/Standby, Working/Active) of each card will be listed in the
Selected Group.
An unprotected card will not be listed in the Protection Groups/Selected Group in the
b.
Maintenance > Protection tabs.
Caution Traffic will be lost during an upgrade on an unprotected card.
Step 4 If the card you are upgrading is unprotected, skip this step and go to
protect card and protect slot. If the card you are upgrading is protected, make sure the protect card is not
active. If the card status is Protect/Active, perform a switch so that the working card becomes active:
Double-click the protection group.
a.
b. Click the Protect/Active card.
c. Click Switch.
Click Yes in the confirmation dialog box.
d.
Physically remove the protect DS3-12 or the protect DS3N-12 card:
Step 5
Open the DS3-12 or DS3N-12 card ejectors.
a.
Slide the card out of the slot. This raises the
b.
is complete.
Right-click the protect slot and choose Change Card from the drop-down list.
Step 6
Choose the new card (DS3-12E or DS3N-12E) from the Change to: drop-down list.
Step 7
Click OK.
Step 8
Insert the new DS3-12E or DS3N-12E card into the protect slot:
Step 9
a. Open the ejectors on the DS3-12E or DS3N-12E card.
b. Slide the DS3-12E or DS3N-12E card into the slot along the guide rails.
Close the ejectors.
Step 10
Wait for the IMPROPRMVL alarm to clear and the card to become standby.
If you switched traffic in
Step 11
In the Maintenance > Protection tabs, double-click the protection group that contains the reporting
a.
card.
Click the selected group.
b.
Click Clear and click Yes at the confirmation dialog box.
c.
Repeat Steps
Step 12
Stop. You have completed this procedure.
Cisco ONS 15454 Procedure Guide, R5.0
12-6
Step 4, clear the switch:
3 through 11 for the working card.
Chapter 12
"NTP-A108 Back Up the Database" procedure on
Step 5
alarm, which will clear when the upgrade
IMPROPRMVL
Upgrade Cards and Spans
and ignore references to the
January 2005