Dlp- A357 Create Fc_Mr-4 Rmon Alarm Thresholds - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
After the node icon becomes available (within 1 to 2 minutes), double-click it. On the shelf graphic,
Step 8
observe the following:
•
•
Verify that traffic on the test set connected to the node is still running. If a traffic interruption occurs, do
Step 9
not continue. Refer to your next level of support.
Repeat Steps
Step 10
start of the procedure.
Verify that the TCC2/TCC2P cards appear as noted in
Step 11
Return to your originating procedure (NTP).
Step 12
DLP-A357 Create FC_MR-4 RMON Alarm Thresholds
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
RMON. If you are already logged in, continue with Step 2.
Double-click the FC_MR-4 card where you want to create the RMON alarm thresholds.
Step 2
In card view, click the Provisioning > RMON Thresholds tabs.
Step 3
Click Create. The Create Threshold dialog box appears.
Step 4
From the Slot drop-down list, choose the appropriate FC_MR-4 card.
Step 5
From the Port drop-down list, choose the applicable port on the FC_MR-4 card you selected.
Step 6
From the Variable drop-down list, choose the variable. See
Step 7
threshold variables available in this field.
Table 20-1
Variable
iflnOctets
ifInDiscards
March 2005
The previous standby TCC2/TCC2P card has a green ACT LED.
The previous active TCC2/TCC2P card LEDs go through the following LED sequence: NP (card not
present), Ldg (software is loading), amber SBY LED (TCC2/TCC2P is in standby mode).
2 through 9 to return the active/standby TCC2/TCC2P cards to their configuration at the
This task sets up remote monitoring (RMON) to allow network
management systems to monitor FC_MR-4 ports.
None
NTP-A24 Verify Card Installation, page 4-2
As needed
Onsite or remote
Provisioning or higher
"DLP-A60 Log into CTC" task on page 17-66
FC_MR-4 Threshold Variables Fibre Channel/FICON Line Rate
Mode (MIBs)
DLP-A357 Create FC_MR-4 RMON Alarm Thresholds
Step 5.
at the node where you want to set up
Table 20-1
Definition
Total number of octets received on the interface, including
framing octets.
The number of inbound packets that were chosen to be discarded
even though no errors had been detected to prevent their being
deliverable to a higher-layer protocol.
Cisco ONS 15454 Procedure Guide, R5.0
for a list of the FC_MR-4
20-41