Dlp- A231 Edit A Circuit Name - Cisco ONS 15454 Series Procedure Manual

DLP-A231 Edit a Circuit Name
CTC will not change the service state of the circuit source and destination port in certain circumstances.
For example, if a port is in loopback (OOS-MA,LPBK & MT), CTC will not change the port to IS-NR.
In another example, if the circuit size is smaller than the port, such as a VT1.5 circuit on an STS port,
CTC will not change the port service state from IS-NR to OOS-MA,DSBLD. If CTC cannot change the
port service state, you must change the port service state manually. For more information, see the
"DLP-A214 Change the Service State for a Port" task on page
Return to your originating procedure (NTP).
Step 9
DLP-A231 Edit a Circuit Name
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
From the View menu, choose Go to Network View.
Step 1
Click the Circuits tab.
Step 2
Step 3 If you want to edit a VCAT circuit member name, complete the following steps in the Edit Circuit
window. If not, continue with
a.
b.
Step 4 In the General tab, click the Name field and edit or rename the circuit.
Note
Step 5 Click Apply.
From File menu, choose Close.
Step 6
If you changed the name of a VCAT circuit member, repeat
Step 7
In the Circuits window, verify that the circuit was correctly renamed.
Step 8
Return to your originating procedure (NTP).
Step 9
Cisco ONS 15454 Procedure Guide, R5.0
19-20
This task edits the name of a circuit or VCAT member.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Provisioning or higher
Step
Click the Members tab.
Click the VCAT member that you want to edit, then click Edit Member. The Edit Member window
appears.
Names can be up to 48 alphanumeric and/or special characters. However, to ensure that a
monitor circuit can be created on this circuit, do not make the name longer than 44 characters
because monitor circuits will add "_MON" (four characters) to the circuit name.
4.
Step 6
Chapter 19 DLPs A200 to A299
19-9.
for the Edit Circuit window.
September 2005