Dlp- A349 Clear Selected Pm Counts - Cisco ONS 15454 Series Procedure Manual

Chapter 20 DLPs A300 to A399
Figure 20-5
Card View
Performance
Directions
radio buttons
radio buttons
Click Refresh. All PM counts recorded by the near-end or far-end node for the specified outgoing signal
Step 4
type on the selected card and port appear. For PM parameter definitions, refer to the "Performance
Monitoring" chapter in the Cisco ONS 15454 Troubleshooting Guide.
View the PM parameter names that appear in the Param column. The PM parameter values appear in the
Step 5
Curr (current) and Prev-n (previous) columns. For PM parameter definitions, refer to the "Performance
Monitoring" chapter in the Cisco ONS 15454 Troubleshooting Guide.
Step 6 Return to your originating procedure (NTP).
DLP-A349 Clear Selected PM Counts
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
March 2005
Signal Type Drop-Down Lists for a DS3XM-6 Card
tab
Intervals
Signal-type
port drop-
down list
This task uses the Clear button to clear specified PM counts depending
on the option selected.
None
DLP-A60 Log into CTC, page 17-66
As needed
Onsite or remote
Superuser
Sub-signal Refresh Auto-refresh
drop-down button drop-down list
list
Cisco ONS 15454 Procedure Guide, R5.0
DLP-A349 Clear Selected PM Counts
Baseline Clear Help
button button button
20-35